4.00.39 worked perfectly for me. Thanks.
Thought I'd let you know about my experience with various driver versions. I recently bought this printer and only use it via my home network. Ubuntu 11.04 worked fine with samsung supplied driver. New Laptop with Win8 -> Mint 15 dualboot -> No Printing -> SULDR
Support is listed as:
Printer(s) PPD(Printer Series) Minimum Version Maximum Version Scanning Support
SCX-3405 SCX-3400 4.00.36 - Xerox MFP
So I started with the 4.00.36 version.
....36 = No Printing but could scan (tested with xsane)
Well I lie, I think it printed a test page about 15minutes later. But other than that it was pretty much dead :P
....35 = Printing but no scanning
....39 = All works perfectly :D
Note:
- Had some issues with IPP:// and RAW connections. Which is what it initially defaulted to when adding the printer.
- Best results with either IPP14:// and LPR/LPD (dnssd://) when using the 1st 2x drivers.
- Installed both configurators versions with the 1st 2 drivers, but they didn't change my results above.
- Therefor used dnssd:// with .39 from the start. No need for the configurator
(Device URI = dnssd://samsung%20scx-3400%20series%20(*****************)._printer._tcp.local/ Whatever that means :P )
Thought I'd let you know about my experience with various driver versions. I recently bought this printer and only use it via my home network. Ubuntu 11.04 worked fine with samsung supplied driver. New Laptop with Win8 -> Mint 15 dualboot -> No Printing -> SULDR
Support is listed as:
Printer(s) PPD(Printer Series) Minimum Version Maximum Version Scanning Support
SCX-3405 SCX-3400 4.00.36 - Xerox MFP
So I started with the 4.00.36 version.
....36 = No Printing but could scan (tested with xsane)
Well I lie, I think it printed a test page about 15minutes later. But other than that it was pretty much dead :P
....35 = Printing but no scanning
....39 = All works perfectly :D
Note:
- Had some issues with IPP:// and RAW connections. Which is what it initially defaulted to when adding the printer.
- Best results with either IPP14:// and LPR/LPD (dnssd://) when using the 1st 2x drivers.
- Installed both configurators versions with the 1st 2 drivers, but they didn't change my results above.
- Therefor used dnssd:// with .39 from the start. No need for the configurator
(Device URI = dnssd://samsung%20scx-3400%20series%20(*****************)._printer._tcp.local/ Whatever that means :P )