- Welcome to Samsung Unified Linux Driver Repository Forum.
| SULDR | Forums | Supported Printers | Printing Questions | Scanning Questions | General Questions | Samsung Installer |
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages1
#1
Scanning / Re: M2875FW rebooting upon scan over the network
May 03, 2016, 15:10:19 #2
Scanning / Re: M2875FW rebooting upon scan over the network
May 02, 2016, 13:02:59
Yes, I have just tried it but the result is the same. However it seems that the problem is only present if I choose xerox_mfp:libusb.
If I select smfp: upon XSane startup I am able to scan with the flatbed scanner but there is no ADF option.
I have also reported the issue to samsung support. They suggested to get the device repaired, but it is more likely a driver or firmware issue I guess.
If I select smfp: upon XSane startup I am able to scan with the flatbed scanner but there is no ADF option.
I have also reported the issue to samsung support. They suggested to get the device repaired, but it is more likely a driver or firmware issue I guess.
#3
Scanning / Re: M2875FW rebooting upon scan over the network
May 01, 2016, 13:08:41
Hi!
The exact same error happens with Samsung Xpress M2885FW. I have installed the following components:
Unpacking samsungmfp-scanner (2:2) ...
Beállítás: suld-network-2 (4.01.17-1) ...
Beállítás: suld-driver-common-1 (1-7) ...
Beállítás: suld-ppd-2 (4.01.17-3) ...
Beállítás: suld-driver-4.01.17 (4.01.17-3) ...
Beállítás: samsungmfp-scanner (2:2) ...
The scanner is connected to the computer via USB so it is not related to the network configuration. If using the scanning process starts and about half of the page the device restarts itself with the same error message:
PCS_Parser.c 20
34 CPCS
The exact same error happens with Samsung Xpress M2885FW. I have installed the following components:
Unpacking samsungmfp-scanner (2:2) ...
Beállítás: suld-network-2 (4.01.17-1) ...
Beállítás: suld-driver-common-1 (1-7) ...
Beállítás: suld-ppd-2 (4.01.17-3) ...
Beállítás: suld-driver-4.01.17 (4.01.17-3) ...
Beállítás: samsungmfp-scanner (2:2) ...
The scanner is connected to the computer via USB so it is not related to the network configuration. If using the scanning process starts and about half of the page the device restarts itself with the same error message:
PCS_Parser.c 20
34 CPCS
Pages1
| Repository Information | Legal | Contact | Alternative Drivers |